UNIQUE SERIES AKTU Syllabus
BEE651

Power System-II Lab

L-T-P0-0-2 Credits1 Session2024-25 TypeLab / Practical
Appears in 2 semesters · 2 branches

B.Tech Electrical Engineering · Sem 6 (Lab) · B.Tech Electrical & Electronics Engineering · Sem 6 (Lab)

Download PDF

Pre-requisites: Power System-I Lab

List of Experiments / Activities

  1. 1To determine fault current for L-G, L-L, L-L-G and L-L-L faults at the terminals of an alternator at very low excitation.
  2. 2To Study the over-current relay and the effect of PSM and TSM.
  3. 3To study percentage differential relay.
  4. 4To study Impedance, MHO and Reactance type distance relays and zones of protection.
  5. 5To study Ferranti effect of a transmission line/cable.
  6. 6To measure the dielectric Strength of transformer oil.
  7. 7To study the Synchronization of alternator with infinite bus bar.
  8. 8To determine positive sequence, negative sequence and zero sequence reactance of an alternator.
  9. 9To Study the effect of different shape of electrodes on dielectric (air) breakdown.
  10. 10To Study the gas actuated Buchholz relay for oil filled transformer.
  11. 11To determine the sub-transient (xd″), transient (xd′) and steady state reactance (xd) of a synchronous machine. * The available Experiments from above list may be performed on virtual lab on following virtual lab link: http://vlab.co.in/ (B) Simulation Based Experiments (using Scilab/MATLAB or any other equivalent open source software platform)
  12. 1To obtain formation of Y-bus.
  13. 2Perform load flow analysis on a 3- Bus System using G-S Method.
  14. 3Perform load flow analysis on a 3- Bus System using N-R Method.
  15. 4To perform symmetrical fault analysis in a power system.
  16. 5To perform unsymmetrical fault analysis in a power system.
  17. 6Swing Curve by Step-by-Step Method.
  18. 7Determination of the stability of a SMIB system in occurrence of a fault by solving the Swing equation by Euler’s Method.
Course Outcomes (COs)5 outcomes

After completion of the course student will be able to:

  1. CO1Test various relays for different characteristics and compare with the performance characteristics provided by manufacturers.K4
  2. CO2Select the power system data for load-flow and fault studies and to develop a program to solve power flow problem using NR and GS methodsK6
  3. CO3Analyze various types of short circuit faultsK4
  4. CO4Demonstrate different numerical integration methods and factors influencing transient stabilityK3
  5. CO5Determine the effect of load in long transmission line Note: - Minimum 10 experiments are to be performed from the following list: (A) Hardware Based Experiments:K3

Text Books

  1. -
  2. Haadi Sadat, “Power System Analysis” Tata McGraw Hill.
  3. T.K. Nagsarskar & M.S. Sukhija, Power System Analysis’ Oxford University Press.
  4. K. Umarao, “Computer Techniques and Models in Power System”, Wiley

Official AKTU syllabus

This subject is on page 22, 23 of the original AKTU PDF.

Official AKTU syllabus PDF ↗