Pre-requisites: Basic Electrical Engineering
List of Experiments / Activities
- Ten experiments to be performed:
- 1Verification of Maximum power transfer theorem.
- 2Verification of Tallegen's theorem.
- 3Study of phenomenon of resonance in RLC series circuit and obtain resonant frequency.
- 4Design and find cut-off frequency of low pass and high pass filters.
- 5Design and find the pass band frequencies of band pass filters.
- 6Design and find the stop band frequencies of band reject filters.
- 7Determination of two port network Z and h parameters.
- 8Verification of parameters properties in interconnection of 2, two port networks in series-series interconnection.
- 9Verification of parameters properties in interconnection of 2, two port networks in parallel-parallel interconnection.
- 10Determination of Z parameters of a T network and Computation of corresponding parameters to equivalent π network.
- 11To perform the transient response of RL circuit.
- 12Verification of parameters properties in interconnection of 2, two port networks in cascade interconnection.
- Note: Any two experiments from above list should also be performed by students on Virtual Lab.
Course Outcomes (COs)
After completion of the course student will be able to:
- CO1Understand basics of electrical circuits with nodal and mesh analysis.K2
- CO2Appreciate electrical network theorems.K3
- CO3Analyse RLC circuits.K3
- CO4Determine the stability of an electrical circuit.K2
- CO5Design network filters. KL- Bloom’s Knowledge Level (K1, K2, K3, K4, K5, K6) K1 – Remember K2 – Understand K3 – Apply K4 – Analyze K5 – Evaluate K6 – CreateK2
Official AKTU syllabus
This subject is on page 18 of the original AKTU PDF.