BEE351

Circuit Simulation Lab

L-T-P0-0-2 Credits1 Session2023-24 TypeLab / Practical
Appears in 3 semesters · 3 branches

B.Tech Electrical Engineering · Sem 3 (Lab) · B.Tech Electrical & Electronics Engineering · Sem 3 (Lab) · B.Tech Electrical & Computer Engineering · Sem 3 (Lab)

Pre-requisites: Basic Electrical Engineering

List of Experiments / Activities

  1. Ten experiments to be performed
  2. 1Verification of principle of Superposition with AC sources using Multisim/ PSPICE.
  3. 2Verification of Thevenin and Maximum Power Transfer theorems in AC Circuits using Multisim/ PSPICE.
  4. 3Verification of Norton theorems in ACCircuits using Multisim/ PSPICE.
  5. 4Verification of Tellegen’s theorem for two networks of the same topology using Multisim/ PSPICE.
  6. 5Determination of Z and h-parameters (DC only) for a network and computation of Y and ABCD Parameters using Multisim/ PSPICE.
  7. 6Determination of driving point and transfer functions of a two port ladder network and verify with theoretical values using Multisim/ PSPICE.
  8. 7Determination of transient response of current in RL and RC circuits with step voltageinput.
  9. 8Determination of transient response of current in RLC circuit with step voltage inputforunder damped, critically damped and over damped cases.
  10. 9Determination of image impedance and characteristic impedance of T and Πnetworks, using O.C. and S.C. tests.
  11. 10Verification of parameter properties in inter-connected two port networks: series, parallel and cascade using Multisim/ PSPICE.
  12. 11Determination of frequency response of a Twin – T-notch filter.
  13. 12To determine attenuation characteristics of a low pass / high pass active filters.
  14. Note: Any two experiments from above list should also be performed by students on Virtual Lab.
Course Outcomes (COs)5 outcomes

After completion of the course student will be able to:

  1. CO1Apply the knowledge of basic circuital law, nodal and mesh analysis for given circuit.K2
  2. CO2Analysis of the AC and DC circuits using simulation techniques.K3
  3. CO3Analysis of transient response of AC circuits.K3
  4. CO4Evaluation and analysis of two-port network parameters.K2
  5. CO5Estimation of parameters of different filters. KL- Bloom’s Knowledge Level (K1, K2, K3, K4, K5, K6) K1 – Remember K2 – Understand K3 – Apply K4 – Analyze K5 – Evaluate K6 – CreateK2

Official AKTU syllabus

This subject is on page 10 of the original AKTU PDF.

Official AKTU syllabus PDF ↗