UNIQUE SERIES AKTU Syllabus
BEC452

Analog Circuits Lab

L-T-P0-0-2 Credits1 Session2023-24 TypeLab / Practical
Appears in 5 semesters · 5 branches

B.Tech Electronics & Communication Engineering · Sem 4 (Lab) · B.Tech Electronics & Instrumentation / Instrumentation & Control · Sem 4 (Lab) · B.Tech Electronics & Computer Engineering · Sem 4 (Lab) · B.Tech ECE (Advanced Communication Technology) · Sem 4 (Lab) · B.Tech Electronics Engineering (VLSI Design & Technology) · Sem 4 (Lab)

Download PDF

List of Experiments / Activities

  1. ANALOG CIRCUIT LAB 0L:0T:2P 1 Credits SUGGESTIVE LIST OF EXPERIMENTS
  2. 1Characteristic of BJT: Study of BJT in various configurations (such as CE/CS, CB/CG, CC/CD).
  3. 2BJT in CE configuration: Graphical measurement of h-parameters from input and output characteristics, measurement of Av, AI, Ro and Ri of CE amplifier with potential divider biasing.
  4. 3Study of Multi-stage amplifiers: Frequency response of single stage and multistage amplifiers.
  5. 4Feedback topologies: Study of voltage series, current series, voltage shunt, current shunt, effect of feedback on gain, bandwidth etc.
  6. 5Measurement of Op-Amp parameters: Common mode gain, differential mode gain, CMRR, slew rate.
  7. 6Applications of Op-Amp: Op-Amp as summing amplifier, difference amplifier, integrator and differentiator.
  8. 7Field effect transistors: Single stage common source FET amplifier –plot of gain in dB vs frequency, measurement of bandwidth, input impedance, maximum signal handling capacity (MSHC) of an amplifier.
  9. 8Oscillators: Study of sinusoidal oscillators- RC oscillators (phase shift, Wien bridge etc.).
  10. 9Study of LC oscillators (Hartley, Colpitt, Clapp etc.),
  11. 10Study of non-sinusoidal oscillators.
  12. 11Simulation of amplifier circuits studied in the lab using any available simulation software and measurement of bandwidth and other parameters with the help of simulation software.
  13. 12ADC/DAC: Design and study of Analog to Digital Converter.
  14. 13Design and study of Digital to Analog Converter.
Course Outcomes (COs)5 outcomes

After completion of the course student will be able to:

  1. CO1Understand the characteristics of transistors.
  2. CO2Design and analyze various configurations of amplifier circuits.
  3. CO3Design sinusoidal and non-sinusoidal oscillators.
  4. CO4Understand the functioning of OP-AMP and design OP-AMP based circuits.
  5. CO5Design ADC and DAC.

Note: The AKTU syllabus PDF of some branches prints this subject with small differences in the experiments (Electronics & Computer). Please also check the official AKTU PDF of your branch, linked at the end of your semester page.

Official AKTU syllabus

This subject is on page 15 of the original AKTU PDF.

Official AKTU syllabus PDF ↗